How to use: DH-1012 Open the package, install the press bar in place according to the angle on the picture, tighten the screws on the press bar with a hexagonal wrench, connect the power cord, the power supply must be well grounded, turn on the power switch, the green indicator light is on , Every time you start to use, the machine has a process of heating up. After the green indicator light goes out, it can start to work.
Open the package of DH-1012T, install the press bar in place according to the angle on the picture, tighten the screws on the press bar with a hexagonal wrench, buckle the thermostat knob cover in the direction of the bayonet, adjust the knob temperature to 220°C, Connect the power cord, the power supply must have a good grounding, turn on the power switch, then the green indicator light is off, when the temperature rises to the adjusted temperature, the indicator light is on, and you can start working.
Pass the paper-plastic bag out between the heating belt and the silica gel strip, press the right side handle down, and simultaneously press down the paper cutter and slide the cutter horizontally to cut the paper-plastic composite bag. Just lift the pressure handle.
Note: This machine is a direct heating method. When using for a long time, pay attention to whether the knife holder is overheated to avoid burns.
Safety instructions: The wire between the power socket and the casing must be firmly grounded. Please pay attention to the temperature of the outer knife holder to prevent burns if it is used continuously for a long time.
PHP
USD
HKD
